Kemppi Adaptive 150 - Manual (Page 17)

MinarcMig™ Adaptive 150
16 © Kemppi Oy 0550
EN
Changing the wire guide
If the wire guide is too worn or totally clogged, change it to a new one according
to the following instructions:
1. Disconnect the welding gun from the machine.
a. Disconnect the cable clamp of the gun’s power cable by opening the
screws.
b. Disconnect the gun’s power cable from the machine’s pole.
c. Disconnect the connector of the trigger conductors from the machine.
d. Open the gun’s mounting nut.
e. Extract the gun gently from the machine whereupon all parts come
through the front part’s cable hole.
2. Open the mounting nut of the wire guide which exposes the end of the
wire guide.
3. Straighten the welding gun’s cable and withdraw the wire guide from the
gun.
4. Push a new wire guide in to the gun. Make sure that the wire guide enters
all the way into the contact tip’s adapter and that there is an o-ring at the
machine-end of the guide.
5. Tighten the wire guide in place with the mounting nut.
6. Cut the wire guide 2 mm from the mounting nut and file the sharp edges of
the cut round.
7. Reattach the gun in place and tighten the parts to spanner tightness.
4.3. MACHINE DISPOSAL
Do not dispose of electrical equipment together with normal waste!
In observance of European Directive 2002/96/EC on Waste Electrical and
Electronic Equipment and its implementation in accordance with national
law, electrical equipment that has reached the end of its life must be collected
separately and returned to an environmentally compatible recycling facility. As
the owner of the equipment, you should get information on approved collection
systems from our local representative.
By applying this European Directive you will improve the environment and
human health.