Säädöt ja merkkivalot, Controls and indicator lights, Bedienelemente und anzeigen – Kemppi Adaptive 150 User Manual
Page 13: Bedieningselementen en controlelampjes, Boutons et témoins lumineux, Controles e indicadores luminosos, En 3.5. controls and indicator lights
MinarcMig™ Adaptive 150
12
© Kemppi Oy 0550
EN
3.5. CONTROLS AND INDICATOR LIGHTS
Figure 3.6. Machine's front panel
1. Welding power control
2. Arc length trimmer
3. Standby indicator light
4. Overheating indicator light
The welding power is adjusted according to the thickness of the welded sheet.
The machine also has a trimmer for arc length.
Indicator lights display the machine’s standby mode and inform of a possible
overheating.
When you switch the machine on, a green standby light switches on.
Simultaneously, the main switch indicator light switches on. If the machine
overheats or the supply voltage is too low or too high, the welding operation
automatically switches off and the yellow overheating indicator light switches
on. The light switches off when the machine is ready for operation again. Make
sure that there is enough space around the machine allowing air to freely flow
and cool the machine.