Kemppi Protig 410 User Manual
Page 18
EN
3.1.12 Controls for MMA welding
1
2
1.
Select the MMA welding.
2.
Adjust with the +/- keys current needed.
Set value can be seen in display P23 on no-load. At welding the display shows welding
current. When the light H26 for remote control is lighted, you can control welding current
from remote control unit R10.
Don`t forget to change polarity of welding current by changing connection of cables as
shown in figures on page 5 or 6.
3.2
CONTROL PANEL TX 6271266
H26 P23
S29
S28
S21 S22
S24 S51 P51 S27
S23
P25
Read following paragraphs in operation instructions for panel TL:
Selection of MMA/TIG welding (S21)
Selection of TIG ignition method (S22)
Selection of operation mode of torch switch (S23)
Operation of control unit (S27), (S28)
Display for post gas time (P25)
Local and remote control of welding current (H26)
Welding current display (P23)
Controls for MMA welding
16
Pr
oT
ig 410 H
yundai / © Kemppi O
y / 1135
- FastCool 10 (12 pages)
- ArcFeed 300P (20 pages)
- KempCool 10 (12 pages)
- KempCool 40 (14 pages)
- KempactCool 10 (24 pages)
- Procool 10 (11 pages)
- Procool 30 (9 pages)
- KMS 500 (16 pages)
- KM 500 (18 pages)
- MSF 57 (32 pages)
- MF 33 (16 pages)
- MF 29 (18 pages)
- KMS 400 MVU (16 pages)
- FastMig Pulse 450 (30 pages)
- MXF 67 (36 pages)
- GT02SW (18 pages)
- FastMig MS 300 (22 pages)
- SF 54 (14 pages)
- KMS 400 AS (18 pages)
- KM 400 MVU (18 pages)
- MXP 38 (30 pages)
- FastMig X 450 (32 pages)
- FastMig 520 (16 pages)
- MR 300 (14 pages)
- M 420MV (16 pages)
- AS (10 pages)
- Evo 300 (20 pages)
- RA (38 pages)
- Pulse 2800 (17 pages)
- Pulse 3000 MVU (24 pages)
- MIG 2520 (12 pages)
- MIG 2530 (16 pages)
- DT 400 (34 pages)
- ARC800 (16 pages)
- Pulse TCS (38 pages)
- KempArc DT400 (28 pages)
- Kempomat 2100 (14 pages)
- Kempomat 4200 (26 pages)
- Promig 100 (19 pages)
- ProMXE Automotive panel (20 pages)
- Pro Evolution 4200 (17 pages)
- Promig 300 (22 pages)
- Protig 511 (37 pages)
- Promig 200 ML (18 pages)