Kemppi Protig 410 - Manual (Page 16)

EN
3.1.4 Adjustment of control unit
With + and - keys, parameters (time or current) are adjusted to higher or lower values.
Adjustable operation is selected with arrow keys: welding current, current down-slope time or
post gas time.
Adjustment speed is growing during adjustment.
3.1.5 Parallel control unit for welding current
Controlling is directed only on welding current, in which case changing current is rapid in
operation mode. Control unit is operating in parallel with key S39 on right lower corner
of panel if welding current is adjusted from them. Parallel control unit cannot be used for
adjusting times or per cents.
3.1.6 Pre-gas time display and current up-slope time display
Control ranges are 0 – 9 s.
3.1.7 Display of current down-slope time
Control range is 0 – 30 s.
3.1.8 Display of post gas time
Control range is 0 – 99 s.
3.1.9 Display of welding current
On no-load the meter shows set value of welding current and at welding true value.
14
Pr
oT
ig 410 H
yundai / © Kemppi O
y / 1135