Kemppi FastMig X 350 - Manual (Page 19)

17
© Kemppi Oy / 1520
EN
CV PROCESS
Voltage 10…50 V Welding voltage
VoltageMax 10…50 V Set the limit for maximum voltage value
VoltageMin 10…50 V Set the limit for minimum voltage value
Dynamics -9…+9 Factory setting is 0 Controls the short circuit behaviour of the arc. The
lower the value the softer the arc is. The higher the
value the rougher the arc is.
StartPower -9…+9 Factory setting is 0 Adjusts arc ignition
4.4 Welding functions
WISEROOT+ AND OTHER PROCESSES
2T/4T 2T, 4T, MATCHLOG,
USER Factory setting is USER (user
chooses the switching logic) Sets switching logic
HotStart ON, OFF, USER Factory setting is USER (user
chooses ON or OFF)
HotStartLevel -50…+100 % Step: 1
Factory setting 40%
Hot 2T Time 0…9.9 s Step: 0.1
Factory setting is 1.2 s
CraterFill ON, OFF, USER Factory setting is USER (user
chooses ON or OFF)
CraterStart 10…250 % Factory setting is 100% Sets the level of the curve where the crater
filling will start
CraterFillEnd 10…250 %, not
higher than start Step: 1
Factory setting is 30% Sets the level of the curve where the crater
filling will end.
CraterTime 0.0…10.0 s Step: 0.1.
Factory setting is 1.0 s Sets slope time for crate filling
Crater 4T Timer On, OFF Factory setting is OFF ON: if 4T is selected, crater filling will last
at least time that has been adjusted by
CraterTime or as long as trigger is pressed.
OFF: if 4T is selected, crater filling will last
as long as trigger is pressed.
Creep Start 10…99 % Step: 1
OFF, CURVE (OFF=100%)
Factory setting is CURVE CURVE means that the creep start value
comes from welding program.
StartPower -9…+9 Factory setting is 0 Adjusts arc ignition.