Kemppi FastMig Pulse 350 - Manual (Page 13)

EN
Weld Data Check out the values of the last weld
System Config Menu Show device configuration and information
Language Select your menu language
Select Feeder (WF#) Select another parallel wire feeder as a setup target
MMA On/Off Activate MMA welding
4. Adjustment knob
Turn the knob to change the value of the selected parameter. In MMA mode when the
panel is in default initial view (channel information), knob can be used to adjust current.
5. Menu browsing buttons
Use up and down arrows to move the selection up and down in the menu structure. In
MMA mode when the panel is in default initial view (channel information), Up/Down
buttons can be used to adjust Arcforce.
6. Menu shortcut buttons
• F1 (CHANNEL INFO) Displays the basic data recorded to the displayed channel. Pressing
F1 multiple times gives more information of the selected memory channel. Keeping F1
pressed while turning the machine ON restores the menu language to English.
• F2 (USER) Browses and selects users: 1…10, Administrator. When MMA is selected, only
Administrator is allowed.
• F3 (WF#) Selects another wire feeder as a setup target. Panel allows selecting only those
WF numbers that are found connected on the system.
NOTE! FastMig Pulse allows up to 4 wire feeders to be connected to one power source. Only one
wire feeder can be active at a time and must be selected before it will operate.
7. LCD menu display
8. Soft key buttons for menu selection
Use these buttons to select menu items. Their functions depend on selected menu items.
The function is shown on the display.
4.2 Using the menus
4.2.1 Selecting the interface language
The default menu language is English. If you want to select another menu language, do the
following:
1. Connect the mains power and switch on the power source at the main switch.
• If this is the initial system activation (if SYSTEM OFF text is in the display), you may
need to press and hold the POWER ON button in the top left corner of the P 65 control
panel. Hold the button down for 5 seconds.
2. Press the MENU button to display the main menu, which includes 7 menu items.
• You can move around in the menu list by pressing the up and down arrow buttons.
• As you browse the menu item list, the currently selected item is shown at the bottom
of the display, marked as 1/7, 2/7, 3/7 etc.
• The selected menu item is marked with a black arrow-shaped cursor.
3. Browse to the menu item LANGUAGE (5/7) and press the SELECT soft key button.
4. Browse to your language and press the SELECT/SAVE soft key button. Your language
choice is now confirmed and will remain selected unless you change it later.
4.2.2 About memory channels
You can have several setups of welding parameter values for use in various welding
applications. These setups (or welding jobs) are stored on a memory chip in the wire feeder.
Up to 10 user profiles can be defined in one FastMig Pulse unit, and each of them are assigned
up to 10 memory channels. So, you have maximum of 100 memory channels to store your
frequently used welding jobs. In addition to them, there are 10 memory channels available for
MMA use.
11
© Kemppi Oy / 1515