Kanguru QSX Assembly Guide - Manual (Page 5)

5
Assembling Your Kanguru QSX
Carefully slide the Backplate/HDD Bracket assembly partially out of the housing (about 2 2.
inches). caution! Do not try to pull the Backplate/HDD Bracket assembly completely out of
the housing, there is a cable connecting the Backplate to the Faceplate.
Remove the two screws from the sides of the Backplate. This will release the Backplate from the 3.
HDD Bracket. Set aside the two screws in a secure location, you will need them later.
Detach the Backplate from the HDD Bracket and then slide the HDD Bracket completely out 4.
of the housing.
figure 2: Releasing the Backplate/HDD Bracket assembly
figure 3: Removing the Backplate screws
figure 4: Removing the HDD Bracket