JLCooper MCS3 USB - Manual (Page 17)

17
Launch the Target Application
We will refer to the application that you wish to control as the
target application, to distinguish it from the MCS
3
application.
Launch the target application that you desire to control, if it is
not already open.
You use the MCS
3
application to edit Keysets, to make the
MCS
3
do what you want to do to the target application.
While you are editing and fine tuning your Keysets, you may
switch back and forth between the MCS
3
application and the
target application.
Then, quit the MCS
3
application, since it is not needed to use
the MCS
3
. Any time in the future that you open a target
application, the MCS
3
will be ready to control that application.
Once you have created your Keysets, you do not need to open
the MCS
3
application again to use the MCS
3
.
Remember also that if you open an application for which no
Keyset exists, the MCS
3
will use the Default Keyset.
The only times that you ever need to open the
MCS
3
application are when you wish to
Create a New Keyset, Delete a Keyset, Import, Export
or Edit an existing Keyset.
Once you have created the desired Keysets, ordinary daily use
of the MCS
3
does not necessitate launching the MCS
3
application.