Configuring the ethernet interface – JLCooper ES-450SPE User Manual
Page 6
6
Configuring the Ethernet Interface
1. Install the Lantronix Device Installer v4.x.x.x and Redirector
This is located on the Install CD that came with the product.
Alternately, it can be downloaded from the JLCooper Support
Site a
2. Launch Device Installer.
Press Search. The Device Installer application will look for all
the Lantronix products on your network. The factory default of
the Ethernet Interface is 192.168.200.114. If you do not see
this, you will need to change the IP address of your computer
to 192.168.200.nnn (for example, 192.168.200.1) and subnet to
255.255.255.0 so the computer can communicate with the
controller.
Also, if there is more than one Ethernet Interface on the
network, there will be an IP address conflict that will need to
be resolved before using the units.