Configuring the ebox – JLCooper ES-450SPE User Manual
Page 24
24
Configuring the eBOX
Now that the ES-450 is configured, the eBOX must be configured.
In this application, the eBOX will be configured as a TCP server.
In other words, the eBOX will passively sit on the network waiting
for another device to connect to it. In this case, it will be the ES-
450.Before the ES-450 can successfully communicate with the
eBOX, the eBOX must be configured with appropriate parameters.
To configure the eBOX, download and install the eBOX
Configuration Utility from the JLCooper Support website.
Set the eBOX to a known IP Address such as 192.168.254.102 by
setting the rear panel DIP switches as detailed in the chart below:
Launch the application. You will see the following screen.
Dip Switch
1
2
3
4
5
6
7
8
Down
Down
Down
Down
Down
Up
Down
Down