Jetway Computer NC62K - Manual (Page 18)

2-5-2 Headers
(1) USB Port Headers (9-pin): USB1,USB2
These headers are used for connecting the additional USB port plug. By attaching an
option USB cable, your can be provided with two additional USB plugs affixed to the
back panel.
USB Port Header
Pin 1
USB1
VCC
-
DA
TA
GN
D
+D
AT
A
VCC
OC
-
DA
TA
GN
D
+D
AT
A
Pin 1
USB2
VCC
-
DA
TA
GN
D
+D
AT
A
VC
C
OC
-
DA
TA
GND
+D
AT
A
(2)IDE Connector：
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
You may also configure two hard disks to be both Masters using one ribbon cable on the
primary IDE connector and another ribbon cable on the secondary IDE connector.
• Two hard disks can be connected to each connector. The first HDD is referred to as the
“Master” and the second HDD is referred to as the “Slave”.
For performance issues, we strongly suggest you don’t install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
14