Jetway Computer NU93 User Manual

Page 26

suspend button is pressed.
The optional settings are: [Suspend Disabled]; [S3 (Suspend to RAM)].
EUP Function
The optional settings: [Disabled]; [Enabled].
This item should be set as [Disabled], if you wish to have all active wake-up
functions.
Wake-Up by PCIE/LAN from S5
The optional settings: [Disabled]; [Enabled].
PWRON After PWR-Fail
The optional settings are: [Former-Sts]; [Always on]; [Always off].
RTC WakeUp
The optional settings: [Disabled]; [Fixed Time]; [Dynamic Time].
Use this item to enable or disable system wake on alarm event.
When set as [Fixed Time], system will wake on the hour/min/sec specified.
When set as [Dynamic Time], system will wake on the current time + increased
minute(s).

 Super I/O Configuration

Press [Enter] to make settings for the following sub-items:
Super IO Configuration

 Serial Port 1 Configuration
Press [Enter] to make settings for the following items:
Serial Port 1 Configuration
Serial Port
Use this item to enable or disable serial port (COM).
Change Settings
Use this item to select an optimal setting for super IO device.
Transmission Mode Select
The optional settings are: [RS422]; [RS232]; [RS485].
Mode Speed Select
The optional settings are: [RS232/RS422/RS485=250kbps]; [RS232=1Mbps,