Jetway Computer NC9FL User Manual
Page 30
25
USB Transfer time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
The optional settings are: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device reset time-out
Use this item to set USB mass storage device start unit command time-out.
The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device power-up delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller. ‘Auto’ uses default value: for a root port it is 100 ms, for
a hub port the delay is taken from hub descriptor. The optional settings: [Auto];
[Manual].Select [Manual] you can set value for the following sub-item: Device
Power-up delay in seconds, the delay range in from 1 to 40 seconds in one
second increments.
Device Power-up delay in seconds
The delay range is from 1 to 40 seconds, in one second increments.
Super IO Configuration
Press [Enter] to make settings for the following sub-items:
Super IO Configuration
CIR Controller
Use this item to enable or disable CIR controller.
-Device Settings
The current device setting for CIR controller will show on the screen.
CIR LED
The optional settings are: [Disabled]; [Enabled].
When CIR LED is enabled, the CTS of UART is disabled.
ERP Function