Doro 5055 - Manual (Page 28)

English
28 www.doro.com 28 28
The Answering Machine (5065R)
Using the Answering Machine
When new ICM’s are recorded will fl ash in the display and also the
a
button on the back of the handset. Playback will always be new
ICM’s only, the answering machine will then return to standby mode.
Press
2
to playback all messages, starting with the oldest ICM.
1. Ensure the
a
symbol is visible within the display, and the
a
button located on the back of the handset is illuminated.
2. The total number of (new) recorded ICM’s will now be announced.
Before each ICM the day and time the message was received will be
announced, and a short beep will be heard between each message.
3. Listen to your ICM’s, or press
8
to stop playback.
4. Select an operational command from the table below by pressing the
corresponding button.
5. All messages will be saved (unless erased during playback) and new
messages will be recorded after any old messages.
Command
Function
1..................................Repeat/skip to previous message
2..................................Playback of messages
3..................................Skip to next message
42................................Record a MEMO (to stop recording press
8
)
45................................Record new outgoing message, (to stop
recording press
8
)
6..................................Erase individual messages during playback
6 (press & hold)...........Erase all messages after playback
7..................................Switching On the answering machine (the
display will show a )
8..................................Stop
9..................................Switching Off the answering machine (the
display will no longer show a )