Ivoclar Vivadent Liquid Strip User Manual
Page 2
Application
1. Try-in of composite and ceramic restorations
– Application of Liquid Strip on cavity or restoration
– Try-in, evaluation of shade and fit
– Removal of the restoration from the cavity
– Rinsing off Liquid Strip with water and drying with
blower
– Cleansing the restoration with 37 % phosphoric acid
(e.g. Total Etch)
– Thoroughly rinsing off phosphoric acid and drying with
blower
– Further procedure according to information of the luting
composite manufacturer
2. Prevention of oxygen inhibiton with composites
a) Inlay/Onlay luting
– Placement of ceramic or composite restoration with a
luting composite (e.g. Variolink II)
– Removal of excess composite
– Application of Liquid Strip on restoration margins
– Light-curing of the luting composite through Liquid Strip
– Rinsing off Liquid Strip with water
– Finishing/polishing of the restoration
b) Freely built-up composite restorations
– Build-up of restoration
– Covering restoration surface with Liquid Strip
– Light-curing of the composite through Liquid Strip
– Rinsing off Liquid Strip with water
– Finishing/polishing of the restoration
Note
With self-curing composites, glycerine gel has to be left on
restoration until end of setting time.
Important
If a low-viscosity luting composite is used, Liquid Strip has
to be applied carefully, to avoid mixing with, or extruding
of, the composite.
Storage
– Do not use Liquid Strip after expiration date
– Storage conditions: room temperature (2–28 °C /
54–82 °F)
– Shelf life: see expiration date
Keep out of the reach of children!
For use in dentistry only!
Date information prepared
05/2003
Manufacturer
Ivoclar Vivadent AG
FL-9494 Schaan / Liechtenstein
This material has been developed solely for use in dentistry. Processing should be
carried out strictly according to the Instructions for Use. Liability cannot be
accepted for damages resulting from failure to observe the Instructions or the
stipulated area of application. The user is responsible for testing the material for
its suitability and use for any purpose not explicitly stated in the Instructions.