Ivoclar Vivadent Stratos 200 - Manual (Page 11)

32
5.2 Protrusion movement
5.2.1 Protrusive movements can be simulated if the centric
fixation (4.1) is open, according to the schematic below.
The angle of the protrusion path can adjusted to be more
acute or flat (0-60°) by exchanging the corresponding
protrusion inserts.
5.2.2 Protrusion screw (9.0) for centric shift
The protrusion screw permits each condyle to be
incrementally advanced into a protrusive position (See
diagram).
Important
In this case, the centric fixation must not be
used.
5.3 Lateral and Bennett movement
5.3.1 Lateral and Bennett movements
The lateral movements can be simulated when the centric
fixation (4.1) is open, according to the schematic below.
To effect this movement, press with your thumb
unilaterally on the joint of the corresponding side.
The angle can be adjusted to be more acute or flat (15° or
30°) by exchanging the Bennett inserts.
9.0