Ivoclar Vivadent EP5000-G2 - Manual (Page 25)

25
5.8 OSD (Optical Status Display)
The OSD (Optical Status Display) on the side of the operating unit
shows the most important statuses of the furnace. The
following activities are shown:
5.8.1 The start procedure
The handles blink white when the furnace is started. Once the
starting process is completed, the OSD lights up in white or green.
5.8.2 Setting the brightness
The brightness can be set in
5%-steps in the menu „Settings“
(OSD system).
5.8.3 Deactivation
In order to deactivate the OSD,
the brightness has to be set to
0%.
Colour Activity
white (blinking) The furnace is in the switch-on mode (self-
test active)
white Stand-by, the furnace is basically ready to
use
green Operating temperature B of the currently
selected program was reached by +/- 20 °C
yellow (blinking) Information, note or error message
orange Program is in the close-head or preheating
mode
red Program is in the heating mode
magenta Program is in the holding time H mode
blue Program is in the long-term cooling or open-
head mode
turquoise Press program is in the press mode