Daewoo DLT-20J3T - Manual (Page 35)

AV Selection
Setting screen modes
Adjustment of Screen Size in TV and AV mode
- Pressing the “AV” button on the remote control the screen changes as follows:
TV AV1 AV2 Component HDMI PC TV
- When you select HDMI or PC mode, check the following.
1. For optimum picture quality, use to the computer or set top box outputs as shown below.
Using other formats or refresh rates may result in reduced picture quality.
* DLT-19W4/22W4 : 1440 x 900 at 60Hz refresh rate
* DLT-20J1/20J3/20J9 : 640 x 480 at 60Hz refresh rate
2. If the message “No signal” appears on the screen, adjust the PC output to a format listed in the PC input resolu-
tion table on page 19.
Note :
• The menu disappears if you do not operate any button for about 60 seconds from the menu appearing.
• In the case of connecting both composite video signal and S-video signal at the AV3 terminal, the S-video signal
has priority.
• If sound signal is mono only, connect the white phono plug to the LEFT (L)-terminal of the sound input terminal
on the TV.
• See page 17 for connection method of Camcorder and Video.
Setting various screen modes
- User can select various screens designed for a good picture without adjusting The brightness, contrast or colour
individually by pressing the “NORMAL” button on the remote controller.
• The screen changes as follows:
Normal Movie Dynamic Favourite Normal
• The screen adjustment status changes as the following screens are displayed
sequentially whenever pressing the “NORMAL” button.