Daewoo DLT-20J3T - Manual (Page 18)

PC Connection
When connecting with PC(D-Sub) cable.
1. First adjust resolution of the PC (refer to table in page 19). Using the PC’s original monitor.
2. Then disconnect your monitor from your PC and connect between PC and TV set using the D-sub and Audio ca-
ble as shown in the picture below.
3. Turn on the PC and TV set.
4. Select PC mode by pressing the “AV” button on the remote control or ”
” button of the TV set.
#BDLPGUIFUWTFU
1$
1$
When connecting with a HDMI cable.
1. First adjust resolution of the PC (refer to table in page 19). Using the PC’s original monitor.
2. Then disconnect your monitor from your PC and connect between PC and TV set using the HDMI and Audio ca-
ble as shown in the picture below, if necessary. See note below.
3. Turn on the PC and TV set.
4. Select HDMI mode by pressing the “AV” button on the remote control or ”
” button of the TV set.
Note : If the graphic card of the PC only supports a DVI signal, you must connect the Audio cable as shown in
the picture above.
#BDLPGUIFUWTFU