Hypertherm Powermax125 Service Manua - Manual (Page 177)

Powermax125 Service Manual 808070 177
9 – Power Supply Component Replacement
3. Push the cables through the right grommet (see Figure 46 on page 178) from the power board side to the fan side of
the power supply.
4. Remove the green/yellow ground wire screw from the gas filter housing. (See Figure 45.)
5. Remove the CPC port by removing the 2 screws.
Figure 45
6. Remove the 2 screws from the voltage divider board and remove the voltage divider board and attached cables. (See
Figure 46 on page 178.)
CPC port
Ground wire screw