Hypertherm RT60 Retrofit Torch - Manual (Page 26)

PMX600.06
SETUP
RT60 / RT60M Operator Manual 3-3
0
Torch Installation
ቢ
Turn OFF power.
ባ
Remove power cord from power receptacle.
ቤ
1. Align the connector key-way on the torch lead with the connector receptacle on the power supply and
push in until the pins seat.
2. Before tightening, turn the connector securing ring 1/4 turn to the left to ensure that the securing ring
threads and the connector receptacle threads are aligned.
3. Turn the securing ring to the right to tighten.
4. Clean the top of the power supply and apply the new operation label over the existing label.
Receptacle
Securing ring
Operation label
(Part No. 110522)
Key-way
Note: If the receptacle is missing or damaged it should be replaced with a new receptacle.
Part Number Description
028522 MAX42 receptacle
028523 MAX43 receptacle
029962 Powermax800 receptacle
128493 Powermax600 receptacle
129325 Powermax900 receptacle