Hoefer VP200 - Manual (Page 21)

•
p13
Pump on pump support:
3
Remove catchpots at inlet and outlet.
4
Remove the 4 screws affixing the head cover cowling
(W) with a Torx driver T20. Pay attention to the
washers under the screws and remove.
5
Pull of head cover cowling (W) carefully. Do not tilt.
Pump at pump support:
6
Detach the coupling of the connection tube (V) to the
other side of the pump as well as the hose connection
to the inlet/outlet of the vacuum system at the valve
head (O).
7
Open the hose clip (U) by applying the slotted
screwdriver as shown and turn.
8
Pull the tubing off the hose connector.
Step 4
Step 6
Step 3
Step 7
W
O U V