Hoefer SE215 - Manual (Page 4)

Note: Wear gloves to keep
the caster and plates free of
finger marks.
2. Unpacking
Unwrap all packages carefully and compare
contents with the packing list, making sure all
items arrived. If any part is missing, contact
Hoefer, Inc. Inspect all components for damage
that may have occurred while the unit was in
transit. If any part appears damaged, contact the
carrier immediately. Be sure to keep all pack-
ing material for damage claims or for repacking
should it become necessary to return the unit.
3. Assembly
All casters are assembled and used in the manner
described below. Both single concentration gel
and gradient gel instructions are included.
Prepare the gel caster
1
Prepare gel caster, plates and spacers by washing
with a mild detergent and rinsing thoroughly with
deionized water.
2
Periodically remove the U-shaped silicone rubber
gasket and inspect for nicks. If the gasket appears to
be intact, apply a light film of Gel seal lubricant to it
and replace: avoid stretching the gasket by laying it
onto the groove and pressing it into place. (Gel seal
is supplied with the SE250 and SE260 units.)
•
p2