Dixon ZTR 8026D - Manual (Page 13)

13
SPECIFICATIONS
8000 Series (Diesel Version)
CHASSIS: 11 GA - rectangular tube, 7 GA reinforcement
SEAT: Designed for operator comfort with padded back & arm rests.
Seat is adjustable fore & aft. Mounted on operator suspension
system with damper.
MOWER DECK: 2 decks are available. Both are made of 10 GA fabricated welded
construction with 1/4” reinforcement plate. 3 blades combine for
either a 60” or 72” cut width. Deep deck with discharge tunnel.
Cut height approximately 1.5” to 6” via 10 position lift handle.
BLADE DRIVE: “V” belt with electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a Hydro-Gear BDP-21L
pump and White CE wheel motor.
ENGINE: 26 HP Briggs & Stratton Vanguard 950D, 3 cylinder in-line, water
cooled, diesel, horizontal shaft, pressure feed lubrication with spin-
on oil filter, fuel filter with primer pump and water separator,
paper element with cyclone pre-cleaner.
STARTING Electric by key switch operation with safety interlocks on parking
SYSTEM: brake, blade drive clutch and control levers.
TIRES: Front 13-6.5x6
Rear 23-10.5x12
RECOMMENDED Front 16-20 lbs.
TIRE PRESSURE: Rear 8-14 lbs.
CAPACITIES: Fuel - 11 gallons (approximate)
Hydrostat oil system - 4 quart with in-line 25 micron filter
Hydrostat oil recommendation - SAE 20W50 motor oil
Engine - 3.5 quart CF/CF4 10W30 motor oil
Coolant capacity - 2 gallons 50/50 mix
DIMENSIONS: Width 73.5” (60” Deck), 85.5” (72” Deck)
Height 54”
Length 93”
Weight 1330 lbs (60” Deck), 1364 lbs. (72” Deck)
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE