Guntermann & Drunck UserCenter8 - Manual (Page 13)

Guntermann & Drunck GmbH Operating Instructions UserCenter8
Page 10
6.10 Automatic mouse-enable (standard mouse driver)
With this setting you define whether the mouse emulation sends data to the
computer even if the computer has not given an enable. This only works with a
standard mouse.
For enabling the automatic mouse-enable proceed as follows:
•
Call up the setup mode with CTRL + BACKSPACE
The setup mode will be indicated by the flashing of the three
keyboard (NUM-Lock, CAPS-Lock, SCROLL-Lock).
•
For enabling press Q
•
To disable the mouse-enable again press W
After enabling/disabling the automatic mouse-enable the setup mode will be
closed automatically. The three keyboard LEDs stop flashing.
You can always stop the entry by pressing
ESC .
6.11 Automatic mouse-reset
With this setting you define whether UserCenter8 sends a mouse-reset to the
computer during the switch-on or not (does not work with Unix computers).
For enabling the automatic mouse-reset proceed as follows:
•
Call up the setup mode with CTRL + BACKSPACE
The setup mode will be indicated by the the flashing of the three
keyboard LEDs (NUM-Lock, CAPS-Lock, SCROLL-Lock).
•
For enabling press T
•
To disable the automatic mouse-reset againg press Z
After enabling/disabling the automatic mouse-reset the setup mode will be
closed automatically. The keyboard LEDs stop flashing.
You can always stop the entry by pressing
ESC .