Guntermann & Drunck UserCenter8 - Manual (Page 11)

Guntermann & Drunck GmbH Operating Instructions UserCenter8
Page 8
6.6 Transmission of GDFrames
A change of this setting should only be done as agreed with the G&D
service.
For transmitting GDFrames proceed as follows:
•
Call up the setup mode with CTRL + BACKSPACE
•
For transmission press G
•
To disable transmission again press H
After the transmission of GDFrames is enabled/disabled the setup mode will be
closed automatically. The keyboard LEDs stop flashing.
You can always stop the entry by pressing
ESC .
6.7 Defining the double hotkey
With this setting you define whether one or two hotkeys are necessary for
calling up a function.
For this setting you proceed as follows:
•
Call up the setup mode with CTRL + BACKSPACE
•
To enable double hotkeys press A
•
To disable hotkeys again press S
6.8 Setting the HotKeys
With this setting you define the hotkey for calling up Setup and the hold
function.
To change the hotkeys proceed as follows:
•
Call up the setup mode with STRG + BACKSPACE
•
The setup mode will be indicated by the flashing of the three keyboard
LEDs (NUM-Lock, CAPS-Lock, SCROLL-Lock).