Dacor ER30DSR - Manual (Page 9)

6 7
Setting Up Your Range
Cooktop Assembly
Stack Burner Assembly
Put the burner rings on the burner bases as shown below.
Match the correct sizes. The bottom of the correct size burner
ring fits inside the top of the matching burner base.
Turn the ring until it drops into place. Twist each ring back and
forth slightly to make sure it is properly seated.
Put the burner caps on top of the burner rings. The ridge
around the bottom edge of the cap goes around the top of the
burner ring.
1.
2.
3.
Crown Burner Assembly
Put the burner head in place as shown below. The locating tab
on the burner head goes in the keyed hole as shown.
Put the burner ring on the burner head as shown below. Match
the tabs on the bottom of the ring to the slots on the burner
head. Twist each ring back and forth slightly to make sure it is
properly seated.
Put the burner cap on top of the burner ring. The ridge around
the bottom edge of the cap goes around the top of the burner
ring.
1.
2.
3.
Crown Burner Assembly
Ridge on bottom
of Burner Cap
Put locating tab
into keyed hole
Slots
Tabs

Step

Step
 Step
Keyed Hole
Burner Head
Burner Ring
Burner Base
Stack Burner Assembly
Ridge on bottom of
Burner Cap
 Step

Step

Step
Burner Base
Burner Ring
WARNING
To avoid the chance of fire, explosion or carbon monoxide
poisoning, do not attempt to use your range without the burners
completely and properly assembled. The burner rings spread
the flame evenly around the burner cap. The burner rings must
be properly seated for proper burner lighting and operation.
Burner Locations
Crown Burner
Stack Burners