Grandstream GVC3200 Quick Installation Guide User Manual

Page 7

USING THE GVC3200 REMOTE CONTROL

Camera

End Call / Remove

Party From Conference

Volume Up

Send / Answer / Add

Party Into Conference

Shortcut Keys:

Red / Yellow / Blue

Navigation Keys:

Up / Down / Left / Right

Back

Home

Backspace

PIP

Standard Keypad

Presentation

Mute/DND

Volume Down

Zoom In

Zoom Out

Trackpad

# / Information

Power ON / OFF

* / Record

1. Open the battery cover on the back of the remote control. Place two AAA

batteries proprely and put the cover back on.
2. When using the GVC3200 for the first time, the remote control should be paired

and connected to it via Bluetooth already. After the GVC3200 fully boots up, tap

on the OK button on the remote control to initiate the connection. Then the

remote control can be used normally.

Connecting example:

Connect Ethernet cable
from GVC3200 LAN
port to hub/switch/router
(LAN side).

Connect HDMI cable
from GVC3200 HDMI
IN port to laptop’s
HDMI port. This is for
presentation.

Connect HDMI cable from the
GVC3200 HDMI OUT port 1 to
TV’s HDMI port.

Connect the external speaker-
phone to GVC3200 SPKR port.
Use the USB extension cable in
the package if necessary.

6. Insert your SD card into the SD card slot. The recording files will be saved in

SD card.
7. (Optional) Connect presentation device (e.g., a laptop) to the GVC3200 HDMI

IN port or VGA IN port for presentation purpose during conference call.
8. (Optional) Connect USB accessory (e.g., mouse, keyboard, USB flash drive and

etc) to the USB port.

12V DC power
adapter is
connected into
outlet.

Note:
For more information about how to install and connect the GVC3200, please visit

the GVC3200 product web page from http://www.grandstream.com/support

If the remote control is not paired with the GVC3200 anymore (e.g., a factory reset

is made), follow the steps below to pair and connect the remote control:
1. Connect a USB mouse to the GVC3200 USB port. Or, log in the GVC3200 web

UI and click on “Remote Control” on the upper right corner to bring up the

virtual remote control.
2. Use the USB mouse or the virtual remote control to navigate to the idle screen

Menu->Settings->Network->Bluetooth on the TV.
3. Select and click on “Search for devices”.
4. On the remote control, press OK button and number 5 button at the same time

for about 4 seconds. This will initiate pairing process on the remote control.