Grandstream GVC3200 Quick Installation Guide User Manual

Page 5

2. On wall mount bracket Part B, there are four holes on it for screw Type 3. Align

Part B against the wall where you would like to place the wall mount.

5. Mount the wall mount bracket Part B

to the wall. Then put the four screws

Type 3 into each bolt.

4. Fit the four bolts into each hole on the wall. Please make sure the glossy side

is placed outwards. See figure below.

3. According to the position of the four holes on Part B, locate the corresponding

spots on the wall and drill the holes.

INSTALLING BRACKET TO MOUNT THE GVC3200 ON

WALL:

6. Manage the wire harness with the Hook-and-loop fastener on wall mount

bracket Part B.

1. Locate the wall mount bracket in the package and identify Part A and Part B.

Detach Part A from Part B by sliding Part A out.

Slide Part A outwards

Silicon

Stopper

Locating Pin

Built-in

Screw

Part A

Part B

Four holes for wall

mount, using screw

Type 3

6. Tighten the screws so that Part B

can be securely placed against the

wall.

7. Slide the wall mount bracket Part A

into Part B, as indicated in the above

arrow.

5. Install screw Type 1 to each of the two

holes on Part B, as highlighted on the

right.

2 X Screws

Type 1