Grandstream HT503 User Manual - Manual (Page 34)

FIRMWARE VERSION 1.0.14.1 HT503 USER MANUAL Page 32 of 64
Product Model This field contains the product model info, such as HT503.
Software Version Program: This is the main software release. This number is always used for firmware
upgrade. Current release is 1.0.7.6 Boot and Loader are seldom changed.
Bootloader: current version is 1.0.0.9.
Core: current version 1.0.7.1
Base: current version is 1.0.7.6
CPE: current version is 1.0.1.19
System Uptime This shows system up time since last reboot.
PPPoE Link Up This shows whether the PPPoE is up if connected to DSL modem
NAT This shows what kind of NAT the HT503 is connected to. It is based on STUN protocol.
If the detected NAT is symmetric NAT, STUN will not work and Outbound Proxy needed
to make HT503 functioning correctly.
Port Status Displays information regarding the individual FXS ports.
Port Hook Registration DND Forward Busy
Forward
Delayed
Forward
FXS On Hook Registered Yes 613
FXO Idle Registered No 614
• Both FXS port and FXO port are registered with this SIP Server.
• FXS Port user has set Do Not Disturb.
• FXS Port user has set his calls to be forwarded unconditionally to ext 613.
FXO Port user has set his calls to forward to 614 when his phone is busy.
TABLE 8: BASIC SETTINGS
End User Password This contains the password for end user to access the Web Configuration Menu. User
can put new password here. This field is case sensitive with maximum of 25 characters
Web Port This is the device’s internal HTTP server port. Default is 80.
Telnet Server Default is set to YES. Telnet access is allowed to the device in this case. Used only for
special purposes such as debugging and troubleshooting. List of available commands
will be shown by pressing >help command from telnet console.
IP Address • If DHCP mode is enabled, then all the field values for the Static IP mode are not
used (even though they are still saved in the Flash memory.) The HT503 will acquire
its IP address from DHCP in the network.
• PPPoE settings are usually for DSL/ADSL modem users. The HT503 will attempt to
establish a PPPoE session if PPPoE account is set.