Grandstream HT503 User Manual - Manual (Page 33)

FIRMWARE VERSION 1.0.14.1 HT503 USER MANUAL Page 31 of 64
End User and administrator is “123” and “admin” respectively. Only an administrator can access the
“ADVANCED SETTING”, “FXS PORT” and “FXO PORT” configuration pages.
NOTE: If you cannot log into the configuration page by using the default password, please check with
the VoIP service provider. It is most likely the VoIP service provider has provisioned the device and
configured for you therefore the password has already been changed.
Only an administrator can access the “ADVANCED SETTING”, “FXS PORT” and “FXO PORT”
configuration pages. Please reference the GUI pages using the following link:
http://www.grandstream.com/products/ht_series/ht503/documents/ht503_gui.zip .
DEFINITIONS
This section will describe the options in the Web configuration user interface. As mentioned, a user can
log in as an administrator or end-user.
Functions available for the end-user are:

STATUS: Displays the network status, account status, software version and MAC-address of the
phone

BASIC SETTINGS: Basic preferences such as date and time settings, multi-purpose keys and
LCD settings can be set here.
Additional functions available to administrators are:

ADVANCED SETTINGS: To set advanced network settings, codec settings and XML
configuration settings.

FXS PORT: To configure the FXS port.

FXO PORT: To configure the FXO port.
TABLE 7: STATUS PAGE
MAC Address The device ID, in HEX format. This is very important ID for ISP troubleshooting. Both
LAN and WAN MAC addresses are located here. The LAN MAC address is used for
provisioning and is written on the label in the original box as well as on the label located
on the back panel of the device.
WAN IP Address This field shows IP address of the HT503.