Grandstream HT503 User Manual - Manual (Page 31)

FIRMWARE VERSION 1.0.14.1 HT503 USER MANUAL Page 29 of 64
CONFIGURATION GUIDE
CONFIGURING HT503 THROUGH VOICE PROMPT
DHCP M ODE
Follow Table 4 with voice menu option 01 to enable HT503 to use DHCP.
STATIC IP M ODE
Follow Table 4 with voice menu option 01 to enable HT503 to use STATIC IP mode, then use option 02,
03, 04 to set up HT503 ’s IP, Subnet Mask, Gateway respectively.
F IRMWARE S ERVER IP A DDRESS
Select voice menu option 13 to configure the IP address of the firmware server.
C ONFIGURATION S ERVER IP A DDRESS
Select voice menu option 14 to configure the IP address of the configuration server.
U PGRADE P ROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP, HTTP and HTTPS.
F IRMWARE U PGRADE M ODE
Select voice menu option 17 to choose firmware upgrade mode. There are three options:
1) always check, 2) check only when pre/suffix changes, and 3) never upgrade
WAN P ORT W EB A CCESS
Select voice menu option 12 to enable WAN Port Wed Access of the device configuration pages.
CONFIGURING HT503 WITH WEB BROWSER
HT503 ATA has an embedded Web server that will respond to HTTP GET/POST requests. It also has
embedded HTML pages that allow users to configure the HT503 through a Web browser such as
Microsoft’s IE, AOL’s Netscape or Mozilla Firefox installed on Windows or Unix OS. (Macintosh OS is not
included).