Grandstream GXV3240 User Guide - Manual (Page 170)

Firmware Version 1.0.3.37 GXV3240 User Guide Page 168 of 177
ADD WI-FI NETWORKS
1. Once Wi-Fi is turned on, GXV3240 will automatically start the scanning within the range.
2. Go to GXV3240's Settings.
3. Touch Wireless & Network.
4. Touch Wi-Fi Settings.
5. A list of Wi-Fi networks will be displayed as scanning result. Tap on the SSID and enter the correct
password information to connect to the selected Wi-Fi network.
6. The phone will start connecting to the Wi-Fi. The status bar will show Wi-Fi signal strength.
7. Once it's added and the password is remembered, the GXV3240 will connect to it again when the SSID
is within the range.
Figure 146: GXV3240 Connect to Wi-Fi
8. The previous steps allow the GXV3240 to connect the WiFi network with DHCP setting by default. If it
needs to connected the WiFi with static IP or PPPoE setting, please scroll down the setting window and
tap to check the “Show advanced options”. Then the window will show up the IP settings at the bottom.
If the Static is selected, the system will require end user to input IP address, Gateway, Network prefix
length and DNS 1 and DNS 2 addresses. If the PPPoE is selected, the system will require end user to
input PPPoE account ID and password.