Set up pnp application, Enable pnp feature – Grandstream GXV3275 User Guide User Manual
Page 175
Firmware Version 1.0.3.30
GXV3275 User Guide
Page 173 of 187
PNP
The GXV3275 has built in PNP (Plug and Play) application to mass provision for other Grandstream phone
clients. The PNP feature is for other phones to be able to find the configuration path and download their
configuration settings with little or no configurations from GXV3275. It gives the GXV3275 phone
accessibility to many phones’ settings and features that can be configured, making it unnecessary to
configure these settings on other phones themselves.
SET UP PNP APPLICATION
It needs to configure the Account 1’s setting properly before implementing the PNP feature on GXV3275.
1.
Check the Account Active box for Account 1.
2.
In Account 1’s SIP setting page, cancel the Validate Incoming SIP Messages feature.
3.
In Account 1’s SIP setting page, set the SIP transport protocol to UDP.
4.
In the Account 1’s SIP setting page, do not use 5060 as the Local SIP Port. This setting will be
overridden to 0 automatically when the PNP feature is enabled. The port number with 0 refers the port
number will be random.
ENABLE PNP FEATURE
After the settings above, end users can enable the PNP feature for GXV3275. It can be enabled from the
web page or from the LCD screen.
ENABLE FROM WEB PAGE
1.
Log in the GXV3275 web page, browse to Maintenance Upgrade.
2.
Check the Enable PNP Feature box.
3.
In the PNP URL box, type the URL path for the saved configuration file with protocol identifier. For
exampl
The protocol identifier can be selected from tftp, http, and https.
4.
GXV3275 supports the built-in httpd server feature. End users can save the config file in the GXV3275
device and it can be set as a file server transport the files to other phone client. If end user needs this
feature, the config file should save be saved in the directory /Internal Storage/pnp. And the PNP URL
should be point to the pnp directory. For instance, if a user wants to set his GXV3275 as a HTTP file
server, whose IP address is 192.168.1.100, and the config file is saved in the directory /Local
Storage/pnp, it needs to enter
If it needs to transport the file via HTTPS, it
needs to set the Access Method to HTTPS under the page of MaintenanceWeb/SSH Access.