Grandstream Synology User Manual
Page 16
Grandstream Networks, Inc.
Synology configuration guide
Page 16 of 20
IP cameras and IP Video Encoders
Last Update : 04/2013
1. In Surveillance Station Management tab, select the camera on which you want to enable motion
detection, and press Advanced button and select Motion Detection in the list.
2. Motion detection window will appear.
•
Motion detection by Surveillance Station is only available option
•
Detection sensitivity: set sensitivity percentage between 1 to 99%; if you set a smaller
value,
motion detection will be less sensitive and will only be triggered when the
calculated difference between a series of frames is larger than the specified value.
• Threshold: set threshold percentage between 1 to 99%; if you set a larger threshold, motion
detection will be triggered when there is larger motion, or when the calculated difference
between a series of frames exceeds the specified threshold.
• Click Detection Area button, to add areas for motion detection (maximum 10 detection
areas). Motion Detection Area will appear to allow you to Add, Name or Delete a Detection
Area. Press Add to specify a new Detection Area, and set a Name for it. Confirm with Ok, and
Save.
(You can adjust the size of Detection Areas by dragging small squares)
When a Motion Detection event is triggered, a recording will be saved (depending on your settings)
- Figure 17: Management – Advanced > Motion Detection
- Figure 18: Motion Detection Area