Grandstream Wavestore - Manual (Page 8)

Grandstream Networks, Inc. WaveStore configuration guide
Page 8 of 16
www.grandstream.com
IP cameras and IP Video Encoders/Decoders
Last Update : 04/2013
b. In Network Capture section, configure the following :
i. Camera Type : Select “Grandstream”
By selecting Grandstream, Wavestore will stream video from Primary Stream.
When using Grandstream IP Video Encoder GXV3504; Camera Type can be
Grandstream : First channel/port
Grandstream ch2 : Second channel/port
Grandstream ch3 : Third channel/port
Grandstream ch4 : Fourth channel/port
ii. Request : This field will change automatically depending on which channel you selected
previously.
By default, the streaming will be over TCP, if you need to use UDP, add U in the request
as follow : /0 or /0 (when using first channel)
Notes : Each Grandstream IP camera has 2 video streams, Primary and secondary
stream.
To stream from the Secondary stream, you will need to change the request to /4
(For example : /4 or /4)
/0 is Primary stream
/4 is Secondary stream
iii. IP Address : Enter the IP address of your IP camera or IP Video Encoder (for example :
192.168.50.143)
iv. Use Custom Port : By default, this option is not checked and the field will be configured
automatically to use default RTSP port 554. If you are using a different port on your IP
camera, you need to check this option and specify the port used.
v. Username : Enter “admin”
- Figure 7: General section, Device settings -