Grandstream Wavestore User Manual
Page 11
Grandstream Networks, Inc.
WaveStore configuration guide
Page 11 of 16
IP cameras and IP Video Encoders/Decoders
Last Update : 04/2013
c. Save to apply your settings.
2- Configuring your Wavestore server
a. Starting from step 5 (described above), select HTTP in Type list under General section
b. In Network Capture section, configure the following :
i. Camera Type : Select “Custom”
ii. Request : In this field you will need to enter the following :
/goform/stream?cmd=get&channel=0
Channel=0 is for Primary stream, for Secondary stream use channel=4
iii. IP Address : Enter the IP address of your IP camera or IP Video Encoder (for example :
192.168.50.143)
iv. Use Custom Port : By default, this option is not checked and the field will be configured
automatically to use default HTTP port 80. If you are using a different port on your IP
camera, you need to check this option and specify the port used.
v. Username : Enter “admin”
vi. Password : Enter “admin” (if using default password)
- Figure 12: General section, Device settings -