Geist Watchdog 100 - Manual (Page 16)

GM1118 - Watchdog 100 Series User Manual 16 Revision Date: 2/16/2015
User account names may include alphanumeric characters, spaces and underscores. Passwords
may include alphanumeric characters and underscores.
Note: The Administrator account must be active to enable the Control Access and View-Only accounts.
Note: The Control Access account must be active to enable the View-Only account.
Note: The account names “root” and “admin” are disabled for security reasons and cannot be re-enabled.
Warning: Record your passwords. To reset lost passwords, follow the instructions for resetting the unit’s
IP address and passwords given in the Default IP Address section (page 6).
Admin Information
Information entered in the Admin Info section of the Admin tab of the Configuration page will
show up at the bottom of the unit’s web interface.
Figure 15: Admin Information Configuration Section
Figure 16: Admin Information Display
Camera Configuration
Enter the domain names/IP addresses and models of up to four IP-addressable network cameras
in the Cameras section on the Configuration page. The unit will present a linked snapshot from
each camera on the Sensors page.
Figure 17: Cameras Configuration Section
Note: Each camera must be set to allow anonymous access to enable this feature.