beautypg.com

Using homelink, Reprogramming a single homelink button, Reprogramming a single homelink௡ button – Dodge 2008 Durango User Manual

Page 172

background image

Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.

It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.

If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3 with the following:

3. Continue to press and hold the HomeLink

button

while you press and release - every two seconds
(“cycle”) your hand-held transmitter until HomeLink

has successfully accepted the frequency signal. The
EVIC display will change from “CHANNEL # TRAIN-
ING” to “CHANNEL # TRAINED.”

If you unplugged the device for training, plug it back in
at this time.

Then proceed with Step 4 under “Programming
HomeLink.” earlier in this section.

Using HomeLink

To operate, simply press and release the programmed
HomeLink

௡ button. Activation will now occur for the

trained device (i.e. garage door opener, gate operator,
security system, entry door lock, home/office lighting,
etc. The hand-held transmitter of the device may also be
used at any time.

Reprogramming a Single HomeLink

Button

To re-program a channel that has been previously
trained, follow these steps:

1. Turn the ignition switch to the ON/RUN position.

2. Press and hold the desired HomeLink

௡ button for 20

seconds until the EVIC display states “CHANNEL #
TRAINING.” Do not release the button.

172

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

This manual is related to the following products: