beautypg.com

Programming homelink – Dodge 2008 Durango User Manual

Page 169

background image

WARNING!

Vehicle exhaust contains carbon monoxide, a danger-
ous gas. Do not run your vehicle in the garage while
training the transceiver. Exhaust gas can cause seri-
ous injury or death.

Programming HomeLink

Before You Begin
If you have not trained any of the HomeLink

௡ buttons,

erase all channels before you begin training.

To do this, press and hold the two outside buttons for 20
seconds. The EVIC will display “CLEARING CHAN-
NELS.” Release the buttons when the EVIC message
states “CHANNELS CLEARED.”

It is recommended that a new battery be placed in the
hand-held transmitter of the device being programmed

to HomeLink

௡ for more efficient training and accurate

transmission of the radio-frequency signal.

Your vehicle should be parked outside of the garage
while training.

1. Turn the ignition switch to the ON/RUN position.

2. Place the hand-held transmitter 1–3 inches (3–8 cm)
from the HomeLink

௡ buttons while keeping the EVIC

display in view.

For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink

௡.

3. Simultaneously press and hold both the chosen
HomeLink

௡ button and the hand-held transmitter button

until the EVIC display changes from “CHANNEL #
TRAINING” to “CHANNEL # TRAINED.”

Then release both the HomeLink

௡ and hand-held trans-

mitter buttons.

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

169

3

This manual is related to the following products: