GAMMA 5003 STRINGING MACHINE 2 POINT SC MOUNTING (Issue 5B - February 2014) - Manual (Page 5)

5
ASSEMBLY INSTRUCTIONS
Base Leg Assembly
The stringing machine uses a four leg base
design. The legs must be assembled to the
lower column support before use. This is the
larger of the two posts with the GAMMA label.
Note: For illustration purposes, the support
column has been painted white for these
instructions.
Align the holes in the leg fl ange with the
matching holes in the lower column support
post. Secure the leg with one FLAT HEAD
cap screw through the upper hole, and one
SOCKET HEAD cap screw through the bot-
tom hole. Repeat this procedure for the three
remaining legs.
Base Foot Height Adjustment
Each foot of the Base Stand can be adjusted
to compensate for uneven surfaces.
Upper Column Support Assembly
The upper column support is shipped inside
of the lower column support. Unloosen the
two set screws at the top of the lower column
support / base leg assembly. Extend the up-
per column to the maximum height and lock
in place with the two set screws located at
the top of the lower column support.