Fusion MS-AV700i - Manual (Page 32)

31
DESCRIPTION COLOUR
Battery +12VDC Yellow
Accessory +12V switched Red
Negative Ground Black
Remote Amplifier Enable ouput Blue/White
Dim input [12VDC active] Orange
Telemute input [GND active] Brown
Note : All +12V wiring MUST be fused at the power source end of your cable, with
a 15 A fuse. When the red “Accessory +12V switched” wire is not required in your
installation, it MUST be connected together with the Yellow “Battery +12V” wire at the
MS-700i head unit wiring loom.
When connecting the Dim input ensure the wire gauge used is suitable for the fuse
supplying the circuit being connected to.
ANTENNA CONNECTION
Connect an AM/FM marine antenna.
Note : Do Not Connect to a VHF splitter
AUX INPUT
Connect an Auxiliary source to the left and right RCA (White = L, Red = R).
VIDEO CONNECTION
(MS-IP700i iPod/iPhone video only, MS-AV700i DVD video only)
Connect the composite video output (Yellow = Video) to a TV / LCD monitor
(MS-IP700i iPod/iPhone video is only available if device is inserted in internal dock).
USB CONNECTION
Connect an Apple sync cable (not included), or USB Flash Drive (not included) or
connect the MS-UNIDOCK Portable Media Device Dock (not included)
NMEA2000 / WIRED REMOTE
For connection to a MS-NRX200i Remote (not included).
For connection to an existing NMEA2000 Bus a CAB000852 Drop Cable (not
supplied) and CAB000581 T-Connector (not supplied) are required.
IMPORTANT NOTE:
1. The CAB000851 drop cable supplied with the 700 Series is required for connection
to a FUSION Remote Control Network (FRCN).
Note: FUSION recommends updating all remote(s) software via the MS-700i at time
of installation to ensure compatibility. This can be done via the Update menu. Please
refer to your remote manual for more information.
CONNECTIONS