Fusion MS-RA205 - Manual (Page 6)

6
In some cases a rear support strap (not supplied) may be required. Please use the two holes
indicated above, to attach the strap using two 8 gauge x 8mm self-tapping screws (not supplied).
INSTALLATION WARNING
• Ensure the marine vessels +12V lead is removed from the battery
before any equipment is connected
• Investigate the marine vessels fuel tanks and electrical wiring
locations before you begin installation
• Ensure all wiring is protected to avoid damage
When wiring the MS-RA205, ensure that the wires are away from sharp objects and
that rubber grommets and insulated bungs are used when routing the wiring. Ensure
that when connecting the wires to the speakers and audio system, the terminals and
connections are protected from shorting to each other.
Note: Ensure the antenna cable is routed away from any power cables, and is the minimal
length, as long cable runs will affect AM reception performance.
For optimum radio reception please ensure you use a dedicated AM/FM ground
independent marine antenna.
The use of a VHF splitter is not recommended as this will degrade your marine VHF
radio performance.
Please refer to the following site for further info: www.pacificaerials.co.nz
Note: The head unit is IPx5 rated on the face when correctly bulkhead mounted. Failure to
mount the head unit correctly may void your warranty.
ELECTRICAL WIRING
Caution: The MS-RA205 is designed for vessels with a 12V DC Negative ground electrical system
SiriusXM REMOTE AERIAL
USB
Rear support holes