Fulgor Milano FSH 905 ID TS User Manual
Page 22
22
23
GB
1 ON/OFF
2 + TIMER
3 - Timer
4 Key on LED
5 Key on button
6 Pause on button
7 Pause and Recall involuntary switch-
off LED
8 Heating area and special function
activation indicator
9 Minimum level activation cursor area
10 Maximum level activation cursor area
11 Power Booster (P) activation cursor
area
12 Extension function on icon
13 Timer for cooking area activation
icon
14 Cooking area level display
15 Cooking level illuminated bar
16 Melt function symbol
17 Heating function symbol
18 Simmering function symbol
19 Timer (minutes/seconds) display
20 Timer (minutes/seconds) display
21 Separator dot (hours/minutes)
22 Timer display (hours/minutes)
23 Icon indicating minutes
24 Independent timer icon
Fig. 3
Residual heat indicator
this tells the user that the glass is at a
dangerously high heat in case of contract
with the whole area over the cooking zone.
The temperature is determined using a
mathematical model and any residual heat
is indicated with an “H” by the corresponding
seven-segment display.
Heating and cooling are calculated in
relation to:
- the power level selected (from “0“ to “9“);
- the relay activation period.
After switching off the cooking zone, the
corresponding display shows an “H” until
the temperature in the zone falls below the
critical level (≤ 60°C) in compliance with the
mathematical model.
Protection in the event of
accidental switching on.
- If the electronic control sense continuous
activation of a key for about 10 sec. it
switches off automatically. The control
gives off an acoustic error signal for 10
seconds, warning the user of the presence
of an object on the sensors. The displays
show the permanent error code, which