Datacom Systems SS series SPAN - Manual (Page 30)

Datacom Systems Inc
SPAN and Multi-Link Aggregators/Regenerators • USERguide
30
Figure 22 - VS-1610 Front Panel (1 of 2 in kit) and functional diagram
An explanation of each front panel legend follows:
POWER 1, 2: Two power supplies are provided for each module. Use of the second
power supply is strongly recommended to assure uninterrupted monitor-
ing. Furthermore, connecting the second power supply to a different
external power source circuit than the first power supply eliminates
power as a single point of failure. The POWER 1 and 2 LEDs illuminate
indicating power 1 and 2, respectively, are on. Either LED not illuminat-
ed indicates a defective power source and immediate replacement is
required to insure redundant power integrity.
NETWORK: These ports are either RJ45 or duplex-LC connectors used for connection to
SPAN network connections. The LED Display Code table deciphers the
RJ45 jacks with integrated LEDs that display line status and line speed of
each port. The LED associated with each duplex-LC jack indicates when
light signal has been detected on the respective Rx NETWORK port.
1,000 Mbs
100 Mbs
10 Mbs
Green
Orange
OFF
LED Display Code
Link
Data
Code Left LED
Solid Green
Flashing Green
Code
WITH LINK OR DATA
Right LED
MONITOR: These ports are either RJ45 or duplex-LC connectors used for connection to
NIC MONITOR card connectors of each network monitoring tool. network con-
nections. The LED Display Code Table deciphers the RJ45 jacks with inte-
grated LEDs that display line status and line speed of each port. The LED
associated with each duplex-LC jack indicates when light signal has been
detected on the respective Rx MONITOR port.