Datacom Systems SS series SPAN - Manual (Page 22)

Datacom Systems Inc
SPAN and Multi-Link Aggregators/Regenerators • USERguide
22
2. Connect network cables to the VERSAstream ™ NETWORK duplex-LC ports. The
LED associated with each duplex-LC jack is solid green indicating when light
signal has been detected on the respective Rx NETWORK port.
3. Connect analysis devices to the VERSAstream ™ MONITOR ports. Two DRL494–2m
cables are provided to connect analysis SC ports to the MONITOR duplex-LC ports.
Either, the MONITOR duplex-LC Link LED or the MONITOR RJ45 Link LED is solid
green when link has been established between the respective monitor port and analy-
sis device. The LED is flashing green when data is passed from the respective moni-
tor port to the analysis device.
Full Duplex aggregated Application —
shown in Figure 14,
focuses on monitoring and analyzis of the full duplex aggregated input into one single
stream of data using a FIBERtap
™ in conjunction with the VS-1022SX-SX. This VS-
1022SX-SX is similiar to other VERSAstream ™ SPAN series installations:
To connect the VERSAstream ™ VS-1022SX-SX SPAN Series aggregator/regenerator,
refer to Figure 14 and follow these steps:
Figure 14 - VS-1022SX-SX Hardware Installation
1. Two power supplies are provided. Use of the second power supply is strongly
recommended to assure uninterrupted monitoring. Connect both power supply
barrel connectors into the power 1 and 2 ports, respectively, of the VERSA-
stream
™ . Plug the power supplies into the external power source, furthermore,