Foxconn P4M9007MB-8EKRS2H User Manual
Page 44
Chapter 3 BIOS Description
38
v
Smart FAN Control
This option is used to enable or disable smart fan function. “PWM Mode” can
enable smart fan function.
v
CPU Fan Start Temperature
This option is used to set beginning temperature. when temperature gets to
this value, Smart Fan starts to take effect.
v
CPU Fan Start PWM Value
This option is used to set the beginning rotated speed for Smart Fan.
v
CPU Fan Slope(PWM/
0
C )
This option is used to set the rotated speed level which Smart Fan varies with
variational temperature. When temperature increase one degree, rotated speed
raises the set level.
Load Optimized Defaults
Select this option and press
load the optimized BIOS default settings. Select
load the optimized defaults. Select
The defaults set by BIOS are the optimized performance parameters for the
system, to improve the performance of your system components. However, if
the optimized performance parameters are not supported by your hardware
devices, it will likely cause system reliability and stability issues. If you only want
to load the optimized default for a single option, select the desired option and
press the
Set Supervisor/User Password
The access rights and permissions associated with the Supervisor password are
higher than those of a regular User password. The Supervisor password can be
used to start the system or modify the CMOS settings. The User password can
also start the system. While the User password can be used to view the current
CMOS settings, these settings cannot be modified using the User password.
When you select the Set Supervisor/User Password option, the following message
will appear in the center of the screen, which will help you to set the password:
Enter Password:
Enter your password, not exceeding 8 characters, then press
password you enter will replace any previous password. When prompted, key in
the new password and press
PDF 文件使用 "pdfFactory" 试用版本创建