Foxconn P4M9007MB-8EKRS2H - Manual (Page 20)

Chapter 2 Installation Instructions
14
Serial ATA Connectors: SATA_1, SATA_2
The Serial ATA connector is used to connect the Se-
rial ATA device to the motherboard. These connectors
support the thin Serial ATA cables for primary storage
devices. The current Serial ATA interface allows up to
150MB/s data transfer rate.
SATA _1/2
GND
TX+
1
GND
GND
TX-
RX-
RX+
IEEE 1394a Connector: F_1394 (optional)
The IEEE 1394a expansion cable can be connected
to either the front (provided that the front panel of
your chassis is equipped with the appropriate
interface) or real panel of the chassis.
1 2
GND
+12V
TPB -
GND
TPA -
+12V
TPB +
GND
TPA +
Empty
F_1394
9 10
S/PDIF Out Connector: SPDIF_OUT
The S/PDIF Out connector is capable of providing
digital audio to external speaker or compressed AC3
data to an external Dolby digital decoder.
Note:The empty pin of SPDIF cable should be aligned
to empty pin of SPDIF out connector.
SPDIF_OUT
1
SPDIF_OUT
+5V
GND
Empty
Speaker Connector: SPEAKER
The speaker connector is used to connect speaker
of the chassis.
Audio Connector: CD_IN, AUX_IN (optional)
CD_IN, AUX_IN are So ny stand ard CD audio
connectors,They can be connected to a CD-ROM
drive through a CD audio cable.
CD_IN
1
CD_R
GND
CD_L
AUX_IN
1 AUX_R
GND
AUX_L
SPEAKER
1
SPKJ
NC
+5V
Empty
PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn