Foxconn P4M8907MA-KRS2H - Manual (Page 22)

15
Chapter 2 Installation Instructions
S/PDIF Out Connector: SPDIF_OUT
The S/PDIF out connector is capable of provid-
ing digital audio to external speakers or com-
pressed AC3 data to an external Dolby digital
decoder.
Note:The empty pin of S/PDIF cable should be
aligned to empty pin of S/PDIF out connector.
Speaker Connector: SPEAKER
The speaker connector is used to connect
speaker of the chassis.
SPEAKER
1 SPK (Pull high)
SPKJ
Empty
NC
1 +5 V
GND
Empty
S P D I F _ O UT
SPDIF_OUT
Serial ATA Connectors: SATA_1, SATA_2
The Serial ATA connectors are used to connect
the Serial ATA devices to the motherboard.
These connectors support the thin Serial ATA
cables for primary storage devices. The current
Serial ATA interface allows up to 150MB/s data
transfer rate.
These two serial ATA connectors support RAID
0, RAID 1, JBOD configuration.
SATA_1/2
1
GND GND GND
RX +
RX- TX -
T X +
PDF 文件使用 "pdfFactory" 试用版本创建 Æ Æ www.fineprint.com.cn