Foxconn 45CMX - Manual (Page 37)

Chapter 2 BIOS Description
31
“Delta 1 Temp(℃)” is used to set the temperature delta. When the change
amplitude of temperature achieves the value, the PWM value will increase or
decrease by slope 1.
“Start 2 Temp(℃)”, “Slope 2 Integer Fraction”, “Slope 2 Decimal Fraction”,
“Delta 2 Temp(℃)” is the same with slope 1 curve. The only one difference
is that the value of slope 2 is different from slope 1.
For example, slope 1= 2.500, slope 2 integer fraction = 1, slope 2 decimal
fraction = 0.125, slope 2 = 2.500+1+0.125 = 3.625.
In the automatic mode, the PWM value is subject to the temperature inputs by
linear changing. When the temperature reading is between start 1 temperature
and full limit, the PWM value changes depending on the temperature reading if
the reading exceeds the delta. If the temperature increase X℃, the PWM value
will increase X*slope.
“Sys Start 1 Temp(℃)”, “Sys Start 1 PWM Value”, “Sys Slope 1 Integer
Fraction”, “Sys Slope 1 Decimal Fraction”, “Sys Delta 1 Temp(℃)”, “Sys
Start 2 Temp(℃)”, “Sys Slope 2 Integer Fraction”, “Sys Slope 2 Decimal
Fraction”,“Sys Delta 2 Temp(℃)” is a group of parameters of system smart
fan. Its principle is the same with CPU smart fan.
8.Load Optimized Defaults
This menu can let you load the optimized defaults set by BIOS, which have set
the optimized performance parameters of system to improve the performances
of system components. You can select or and then press to
load or not load the optimized defaults.
9-10. Set Supervisor/User Password
The access rights and permissions associated with the Supervisor password are
higher than those of a regular User password. The Supervisor password can be
used to start the system or modify the CMOS settings. The User password can
also start the system. While the User password can be used to view the current
CMOS settings, these settings cannot be modified using the User password.
When you select the Set Supervisor/User Password option, the following message
will appear in the center of the screen, which will help you to set the password:
Enter Password:
Enter your password, not exceeding 8 characters, then press . The
password you enter will replace any previous password. When prompted, key in
the new password and press .
If you do not want to set a password, just press when prompted to enter
a password, and in the screen the following message will appear. If no password
PDF 文件使用 "pdfFactory" 试用版本创建 Æ Æ www.fineprint.com.cn